2005-2010 Ford Mustang Aftermarket Performance Exhaust System Kit Flowmaster 817460 817496

2005-2010 Ford Mustang Aftermarket Performance Exhaust System Kit Flowmaster 817460 817496


Even with a 4.6L modular engine and over 315
horsepower, the new 2010 Mustang looks better than it sounds. Today we’re going to install
a new Flowmaster 409S Stainless exhaust and show you just how good that Flowmaster sound
and the Ford Mustang go together. Flowmaster has been making performance exhausts
for the Mustang since the birth of the 5L. So today, we’re going to be installing the
Flowmaster 817460 Stainless Steel Exhaust system which includes two 409S Stainless Steel
American Thunder mufflers, which will sound just perfect in this 2010.
Now Flowmaster also offers kits for 2005 through 2010 V6 Mustangs, as well as non-stainless
systems for those of you on a budget. First, we’re going to show you before and
after sound clips, as well as driving acceleration modes. Following that, we’ll overview some
installation for this Flowmaster exhaust. The installation of the Flowmaster American Thunder
system for the 2010 Mustang is very simple. First, we needed to remove the stock exhaust
while being careful not to damage the existing hangers. These will be reused to attach the
Flowmaster American Thunder series mufflers. This system is strictly bolt on. Simply attach
the stock hangers onto the Flowmaster mufflers, raise them into position, and carefully slide
them onto the stock exhaust pipes. Once the mufflers are aligned flat with the bottom
of the car, you tighten the clamps to prevent any leaks. That wrapped up our installation and you can
see for this system, it doesn’t take more than an hour. We installed the Flowmaster’s
American Thunder kit, which provided and impressive sound. A perfect match for America’s favorite
pony car. This system is an axle-back unit. It retains the factory catalytic converters
and doesn’t require any cutting of the stock exhaust. With the 409S Stainless, you’re getting
a complete Flowmaster stainless steel system, giving extra durability and insurance against
rust. And the good news for Mustang fans, is that
not only does Flowmaster make this kit for the 2010 GT and Shelby, but like we mentioned
earlier, also manufactures systems for the V6 and all S197 models. You’ve gotta run a
pony on your grill, they’ve got your covered.

About the Author: Michael Flood

Leave a Reply

Your email address will not be published. Required fields are marked *