Welcome to Dorman Products Toyota Key Fob installation video. Before you begin, this installation in considered simple. No car knowledge is required. Suggested time of installation is 5 minutes. Start with the key out of the ignition. Driver’s side door open and unlocked. Then, insert the key into the ignition without turning and pull it back out. Perform the next 2 steps within 40 seconds. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles at an even pace starting with lock. Close and reopen the driver’s door. Perform the next 4 steps within 40 seconds. Using the power lock switch on the driver’s door, perform 5 lock/unlock cycles at an even pace starting with lock. Insert the key into the ignition cylinder. Turn the ignition to on but do not start the car. Then, turn back to off once to program remote while retaining the original remote codes. Twice to erase all original codes and add a new remote. Three times to check how many remotes are programmed. Or five times to erase all original codes. Remove the key from the ignition. Within 3 seconds, the power door lock should automatically cycle. Perform the next 3 steps within 40 seconds. Press the lock and unlock buttons on the remote simultaneously for 1 second. Immediately after letting go of the lock and unlock buttons press back down on the lock button for 2 seconds. Within 3 seconds, the door lock should cycle once, indicating successful programming. If programming was unsuccessful or to program additional remotes, repeat the previous 2 steps.