Trailer Hitch Installation – 2010 Ford Flex – Curt – etrailer.com


Today on our 2010 Ford Flex, we’ll be
installing the Curt Trailer Hitch Receiver, part number C13110. Now, here’s what or hitch looks like installed
on our vehicle. Now, we’ll go ahead and give you a couple
of measurements in helping you choose some accessories for your hitch, such as a ball
mount, a bicycle rack, or a cargo carrier. From the center of the hitch pin hole to the
outermost edge of the bumper is approximately four inches. From the top of the opening in the receiver
to the ground is approximately 11 and a quarter inches. Now, let’s go ahead and install our hitch. We’ll begin by
pointing out our attachment points. We’ll begin over here on the driver side.

About the Author: Michael Flood

Leave a Reply

Your email address will not be published. Required fields are marked *